JCD Adjustable Temperature Electric Soldering Iron Heater 220V 110V 60W Ceramic Internal Heating Element for 908 Solder

JCD Adjustable Temperature Electric Soldering Iron Heater 220V 110V 60W Ceramic Internal Heating Element for 908 Solder

banggood Professional Tools

8.99$
6.99$
Preparation 1Always keep the tip of the bit cleanensure to coat the bit liberally with solder the first time the iron is switched onNoteInitial tinning is done in order to extend the life of the bit 2Wet the provided sponge prior to using 3Check that the solder wire is ready for use and adequately extended from the case as shown in step 1 in the above illustration below 4Ensure that the bit fits snugly and has adequate contact with the internal element How to change replace bits1After turning the iron onthe bit will commence heating and will be ready for use when the solder wire begins to melt at contact 2Initiate soldering by ensuring the melted solder makes a clean connection between the contacts that you attempting to solder3Move the solder wire and iron away once enough solder is placed and wipe any residual solder using the wet sponge 4Always remember to switch the iron off at the mains and place it in the provided holder while it cools enough to be stored safely Notes1Use safety goggles and take necessary precautions to avoid injury or fire 2The iron heats up quicklySelect a suitable temperature to operate atUsing the iron for long hours and at high temp may shorten the life of the product3Make sure to only switch the iron on when required and switch it off when notin order to reduce the risk of injury and fire 4Clean the soldering tip ever so often to extend its lifeAvoid using abrasive chemicals and surfaces as this coul